LOCK OUT CONFIGURATION ("LK.CF")

Use Lock Out Configuration ("LK.CF") for the following:
    * To enable or disable setpoint changes
    * To enable or disable the RESET button in the run mode
To Enable or Disable Setpoint Changes
1. Press the MENU button until the meter shows "LK.CF" (after "OT.S.O").

2. Press the /DEV button. The meter shows "SP.=E".

3. Press the /MAX button to toggle between:
    "SP.=E" To enable setpoint changes
    "SP.=D" To disable setpoint changes
4. Once desired mode shows, Press the MENU button to store the changes.

To Enable or Disable the RESET button in the Run Mode
1. If accessing this function from the main menu,Press the MENU button until the meter shows "LK.CF". Otherwise, proceed to step 2.

2. Press the DEV button until the meter shows "SP.=E".

3. Press the DEV button again. The meter shows "RS.=E".

4. Press the /MAX button to toggle between:
    "RS.=E" To enable the RESET button in the run mode
    "RS.=D" To disable the RESET button in the run mode.
5. Once desired mode shows, press the MENU button to store the change. The meter returns to the run mode.

To Enable DisplayÆs Program Version:
1. Press the /DEV button. The meter shows one of the following:
    * "L.3=0" ôSETPTSö button will display setpoint values.
    * "L.3=1" "SETPTS" button will display "v.-03" which is the meter's current software version.
2. Press the /MAX button to toggle between the choices above.
3. Press the MENU button to store the changes.

TUNING PROPORTIONAL CONTROLLER

The Proportional Controller is not active unless your meter has analog output capabilities. The menu will display whether analog output is present or not. This function allows you to tune your controller. Select proportional on Output Configuration (refer to Section 15-3) prior to tuning your controller. Include the meter in the process loop and turn on the meter. Allow enough time for the system to settle.

NOTE: Please ...
1. Press the /DEV button. The meter momentarily shows "DEV" followed by a blinking value. This value is the deviation (error) between Reading and Setpoint 1 values. If this error is zero, your controller is tuned. If a value other than zero shows, proceed with step 2.

2.. Press RESET button. The meter shows "TUNE", tuning your controller and canceling any error. Once tuned, the meter shows "RST" and returns to the run mode.
Note: "TUNE" will be active if your meter has analog output capabilities.

 3. Allow enough time for process to settle. Press the /DEV button. Verify that blinking value is zero. If blinking value is not zero, repeat step 2.
  Help Price List Specifications Print Manual Manuals Home
 Home Home  Table of Contents TOC  Back Back  Next Next